1. Plate of kitchen cabinets
The kitchen cabinets must be environmentally friendly. A large part of the formaldehyde release source comes from the plates. Most of the kitchen cabinets are used to store tableware, ingredients, and inferior plates can emit harmful gases for 15 years.
a. Edge banding material of kitchen cabinets
Ordinary edge banding will age in two years, causing problems, and the edge band will be warped after aging. Then, the hand is folded with special brittleness, and then it is quickly swelled and deformed, and the board is scrapped.
b. Cover glue of kitchen cabinets
Glue is also a solidification period. It takes a long time to meet the moisture of the kitchen and may crack.
2, finish treatment of kitchen cabinets
The finish must be well worn, and the good finish can be rubbed with a steel ball without any scratches.
Second, the hardware of kitchen cabinets
The hardware of kitchen cabinets is known as the soul of the kitchen cabinets. If the hardware is not good, there will be iron rust, door cracking, drawer push and pull and other sounds.
(Before screwing the screw, a plug is embedded in this hole. Then the screw is screwed in. It is tightened tighter and it will never loose.)
Third, the countertop of kitchen cabinets
The countertop of kitchen cabinets is an extremely important part of the kitchen. If the countertop is not good, it will appear: scratches, penetration, and table breakage.
The countertops of kitchen cabinets on the market are mostly quartz stone, and the main component of quartz stone is quartz sand. The higher the quartz sand content, the higher the hardness and the higher the density, and the less likely it is to break and bleed.
2. Beam of kitchen cabinets
There are two reasons why the beam breaks:
a. The load-bearing property (bending resistance) of the board is relatively poor.
The countertops are placed on the kitchen cabinets panels, especially the vertical panels of the kitchen cabinets panels. If the force plate of this force plate is poor, it often picks up things, plus the weight of the countertop of this kitchen cabinets, the plate will bend and even break when the time is long.
b, the details of the process are not in place.
There are three aluminum beams at the bottom of the table for support. If the process is not fine, it is very likely to cause breakage.
c, the problem of adding a liner
The plane of the liner is parallel to the force plate above. The table and the lining must be 100% tight fit. If you can't do a 100% tight fit, you will still have a break.
The opening of the countertop basin and the cooktop is the most prone to breakage. Inferior brands have countertops with pores. If you often pick up things, cracks may occur over time. The countertop must be finely polished, the hand is very smooth and does not scratch, and the corner is to be chamfered.
Contact person: Sum Landy
ADD: Room 538,Unit C,Jewel Center No 16 Kangyuan Road,Hangzhou ,China.310015