1. Environmental protection
Buying kitchen cabinets must be environmentally friendly, which is mainly reflected in the sheet, and the glue used for the sheets is urethane resin. There is more than one type of sheet in the home, and the pollution will be superimposed. The solution is to minimize the amount of formaldehyde released from all the selected materials.
a. Edge sealing material
Ordinary edge banding will be aged in two years, and problems will occur. Edge banding will cause an edge after aging. Then it is broken by hand and is particularly brittle. After rapid swelling and deformation, the board is scrapped.
The market is doing a better job with Germany's Swiss Edge banding, which is specifically used in the ship's edge banding, a longer aging period, better sealing.
b. Cover glue
The glue is also a solidification period, a long time, and the moisture of the water in the kitchen may crack.
c. Edge device
Large-scale edge-sealing equipment is machine-finishing, machine edge-sealing, and machine trimming integration completed. When the edge-sealing equipment is in poor condition, it is not evenly coated with glue, and if the coating is insufficient, the degree of adhesion will be insufficient, and the occurrence of edge curling will be particularly serious.
Finishing must be done with a good degree of wear. A good finish can be easily rubbed with a steel ball and no scratches will appear. In the process of using the kitchen cabinets, the product life cycle of the cabinets is relatively long, and it usually takes eight to ten years for home decoration.
The hardware of kitchen cabinets is called the soul of the kitchen cabinet. If the hardware is not good, there will be iron rust cracking, cracking of the door panels, and sounds from the push-pull drawers. There are three best hardware brands in the market:
1) Austrian BLM, the Chinese name is called Blum, there are a lot of famous brands are using this hardware hinge;
2) The German Heidi poetry, it is also on the market;
3) In the worst case, it is ranked third in the world, Germany's Häfele, one of the three major brands, we must take a look at this hardware brand.
Hinged process: Before screwing a hole, a barrier plug is embedded in this hole. After the screw is screwed in, it is tightened tighter and it will never loosen.
The countertop of kitchen cabinets is an extremely important part of the kitchen. If the countertop is not good, it will appear: scratches, penetration, cracks in the table.
The countertops of kitchen cabinets on the market are mostly quartz, and the main component of quartz is actually quartz sand. The higher the silica sand content, the higher the hardness and the greater the density, and the less likely it is to break and bleed.
There are two causes of broken beams:
1) The load-bearing (bending resistance) of this plate is rather poor
The countertops of kitchen cabinets are laid on the kitchen cabinet boards, especially the uprights of the kitchen cabinet panels. If the strength of this board is poor, it often picks up things, plus the weight of the cabinet countertops. After a long time, the board is bent or even broken.
2) The details of the process are not in place. There are three aluminum beams at the bottom of the mesa for support. If the process is not fine, it is very likely to cause fracture.
3) The problem of liner
The plane of the liner is parallel to the above force plate. The countertop must be 100% tightly attached to this liner. If you can't do 100% tight fit, it will still break.
4) Open hole
Openings in countertop of kitchen cabinets basins and cooktops are the most prone to breakage. If the countertops of the inferior brands have holes in their slag, if they are often smashed, they may crack for a long time. The tabletop must be polished carefully. The hand is very smooth and will not scratch the hand, and this corner should be chamfered.
Contact person: Sum Landy
ADD: Room 538,Unit C,Jewel Center No 16 Kangyuan Road,Hangzhou ,China.310015